Rance - SASS # 54090 Posted November 30, 2023 Share Posted November 30, 2023 I’ve had this ol’ felt hat fer about 20 years.. It’s a light gray.. Sangelli? I try to clean it and reshape it about every 8 years or so.. It gets black marks from ejected ammo casings.. been through lots of rain.. and of course hand stains.. Anyhow.. Do any of you cowpokes know what I could use for homemade hat stiffener? Thanks Link to comment Share on other sites More sharing options...
Choctaw Jack Posted November 30, 2023 Share Posted November 30, 2023 Aqua- Net hair spray. Not home-made, but very inexpensive. Goes on clear and gives a little water shedding properties also. Choctaw Link to comment Share on other sites More sharing options...
Chief Rick Posted November 30, 2023 Share Posted November 30, 2023 100% isopropyl alcohol Put it in a spray bottle that allows you to mist it. Mist the alcohol on both sides of the brim and then turn in your hand, with the grain, working the alcohol into the felt. Don't completely soak the hat, work the alcohol in slowly. Link to comment Share on other sites More sharing options...
Buckshot Sheridan Posted November 30, 2023 Share Posted November 30, 2023 Shellac is commonly the stiffener when the are made. Link to comment Share on other sites More sharing options...
Jackalope Posted November 30, 2023 Share Posted November 30, 2023 Healthy blast of spray starch, then half an hour in a low oven. Dunno if that remedy is endorsed by Hat Makers of America, but what came out of the oven was still a hat and it wasn't floppy anymore. Good luck! Link to comment Share on other sites More sharing options...
Griff Posted November 30, 2023 Share Posted November 30, 2023 48 minutes ago, Chief Rick said: 100% isopropyl alcohol Put it in a spray bottle that allows you to mist it. Mist the alcohol on both sides of the brim and then turn in your hand, with the grain, working the alcohol into the felt. Don't completely soak the hat, work the alcohol in slowly. This ↑↑↑ Link to comment Share on other sites More sharing options...
TN Mongo, SASS #61450 Posted November 30, 2023 Share Posted November 30, 2023 Isopropyl alcohol is what D Bar J Hats of Las Vegas uses. They reshaped one of my hats at Border Town a few years ago. Link to comment Share on other sites More sharing options...
J-BAR #18287 Posted November 30, 2023 Share Posted November 30, 2023 Mix 2 parts alcohol (isopropyl, denatured, whatever) and 1 part shellac; spray on the hat. Allow to dry for at least 24 hours at room temperature. Repeat until hat is as rigid as you want. Don't try to speed up drying with heat; wear it for the first hour after each spray treatment. Starch works until it rains. Link to comment Share on other sites More sharing options...
Rip Snorter Posted December 1, 2023 Share Posted December 1, 2023 I have a Resistol my Wife gave me many years ago. Though I have several / many other hats, I'm fond of it and have taken it to Randy at Law Dog Hats twice for refurbishment. Inexpensive, a professional job, and though it is on the verge of irreclaimable I may try one more time. Many hat makers offer restoration. I asked the same question as the OP a couple of years ago but decided to pay an expert. Link to comment Share on other sites More sharing options...
J-BAR #18287 Posted December 1, 2023 Share Posted December 1, 2023 Addendum: I agree with Rip Snorter, use a professional if it is a valuable hat. Use my alcohol/shellac spray only to salvage an old beater. Link to comment Share on other sites More sharing options...
Sedalia Dave Posted December 1, 2023 Share Posted December 1, 2023 @Blackwater 53393 Is a former Hatter. Could explain a lot. Link to comment Share on other sites More sharing options...
Blackwater 53393 Posted December 1, 2023 Share Posted December 1, 2023 Use eight parts denatured alcohol to one part alcohol based shellac. Mix thoroughly and use a utility grade spray bottle to apply. It disappears quickly and dries in an hour or so. It’s fairly waterproof and when it dries it’s not very flammable, at least no more flammable than your hat was to begin with. Clean your hat well before you use the spray. Link to comment Share on other sites More sharing options...
Rance - SASS # 54090 Posted December 1, 2023 Author Share Posted December 1, 2023 Thanks folks.. sounds like the alcohol and shellac combo is the best.. Sure appreciate yer help.. Rance Link to comment Share on other sites More sharing options...
Jax T Posted December 1, 2023 Share Posted December 1, 2023 Catalina hats by Houston did a great job refurbishing a 20 year old resistol hat of mine and were very reasonable. Link to comment Share on other sites More sharing options...
watab kid Posted December 2, 2023 Share Posted December 2, 2023 On 11/30/2023 at 6:53 PM, J-BAR #18287 said: Addendum: I agree with Rip Snorter, use a professional if it is a valuable hat. Use my alcohol/shellac spray only to salvage an old beater. i agree with you and him , if the ha is valuable you need to trust it to a pro , save its value - if your like me , and bought yours at an antique store to abvuse at cowboy action events , then the DIYS makes sense i dont abuse mine intentionally but everything ive ever bought for CAS was purchased as a 'tool' to be used and abused if needed - nothing i bought was intended to be sunday-goin-to-meetin type stuff , me and my God like huntin/fishin/shootin CAS Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.