Seamus McGillicuddy Posted January 22 Share Posted January 22 My niece has an old leather gun belt that belonged to her late father that’s been holding around forty rounds of .45 Colt for many years. Needless to say the brass has a pretty good coating of verdigris and I told her that I’ll try and clean them up. Who has recommendations for how best to clean the brass on loaded cartridges? Thanks for any help. Seamus Link to comment Share on other sites More sharing options...
Eyesa Horg Posted January 22 Share Posted January 22 Brass polish Link to comment Share on other sites More sharing options...
Sedalia Dave Posted January 22 Share Posted January 22 Never Dull Link to comment Share on other sites More sharing options...
Rip Snorter Posted January 22 Share Posted January 22 Denatured Alcohol Link to comment Share on other sites More sharing options...
Brandon A Bovine SASS 27688 Posted January 22 Share Posted January 22 Flitz polish Link to comment Share on other sites More sharing options...
Seamus McGillicuddy Posted January 22 Author Share Posted January 22 Thanks for those replies. Would you use a toothbrush, rag or what? Seamus Link to comment Share on other sites More sharing options...
The Original Lumpy Gritz Posted January 22 Share Posted January 22 Clean the belt loops too. Link to comment Share on other sites More sharing options...
Dusty Sights, SASS # 2782 Posted January 23 Share Posted January 23 I've cleaned brass cases that had verdigris on them with white vinegar and a paper towel. Worked out quite well. :-) Link to comment Share on other sites More sharing options...
Garrison Joe, SASS #60708 Posted January 23 Share Posted January 23 I use Brasso. Use saddle soap and a small nylon brush to scrub inside the loops of the belt. A 20 gauge bore brush is about right for .45 Colt case loops. This is why police stick nickel-plated brass in gun belts. good luck, GJ Link to comment Share on other sites More sharing options...
Matthew Duncan Posted January 23 Share Posted January 23 2 hours ago, Garrison Joe, SASS #60708 said: I use Brasso. Use saddle soap and a small nylon brush to scrub inside the loops of the belt. A 20 gauge bore brush is about right for .45 Colt case loops. This is why police stick nickel-plated brass in gun belts. good luck, GJ Police still use revolvers ? Link to comment Share on other sites More sharing options...
Garrison Joe, SASS #60708 Posted January 23 Share Posted January 23 Ask Barney Fife But then, he really didn't even need a belt with loops. Link to comment Share on other sites More sharing options...
Nostrum Damus SASS #110702 Posted January 24 Share Posted January 24 Disassemble them, dump the powder, de-prime, and wet tumble. ND Link to comment Share on other sites More sharing options...
Seamus McGillicuddy Posted January 28 Author Share Posted January 28 Thanks for all the help. Seamus Link to comment Share on other sites More sharing options...
Cliff Hanger #3720LR Posted January 28 Share Posted January 28 Mu suggestion is to clean all the brass and belt. Then put it way or hang on the wall for the sentimental value. Have a new belt made and make half the loops so the belt weight is cut in half. I never liked the heavy belt full of ammo I was not going to every use. I loaded from a pocket on my shirt. The rounds on the belt and also be cleaned cases, run through the press with no powder and put a bullet in the case. Again less weight. The loops where every other one with every other one pulled flat. Good place for a small silver button. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.