With help I found what I needed, thanks to all

[Johnny Meadows,SASS#28485L]

I acquired a B-SS that these parts were mangled. It's too nice a gun not to replace them, but I haven't been able to find replacement parts.

Any suggestions?

Thank you,

Johnny Meadows

[Larsen E. Pettifogger, SASS #32933]

Gee I was going to say call Johnny Meadows.  I guess that won't work.

[Boggus Deal #64218]

I’d say you, Ole #4, Capt. Sam Evans(to see if Goatneck had any), Midwest Gun Works? 

[Doc Neeley]

Check with Mudflat Mike. He might have one. He's on here so you can PM him.

[Garrison Joe, SASS #60708]

Art's Gun Shop in Missouri has done lots of work on high end Browning shotguns over the years - they might just have some spares.

https://artsgunshop.com/

 

Also, the Browning factory service center in Arnold MO.

Browning Parts
3005 Arnold-Tenbrook Road
Arnold, Missouri 63010-4728
800-322-4626 x3   

 

Or try the 6 "obsolete parts" dealers that Browning recommends, 2 of which are pretty obvious, :

https://www.browning.com/support/parts-service/obsolete-firearm-parts-service.html

With Browning themselves calling out Midwest Gunworks and Western Gun Part Limited in Edmonton Alberta for BSS "obsolete" parts

 

If all else fails, I'll bet a restoration house can probably make new parts, such as Run-N-Iron in Bertrand NE

http://www.runniron.com/contact/index.html

 

good luck  Johnny!   GJ

[Johnny Meadows,SASS#28485L]

I've exhausted all the above recommended sources. Still looking.

Thanks for all the efforts from my Cowboy friends.

JM

I guess I'll try the most likely source by contacting Ol #4.  I hate to deplete his limited source of parts

[Kid Rich]

Try Jack First In Rapid City, SD.

kR

[Billy Boots, # 20282 LTG-Regulator]

Did you try Joe Brisco?

[Happy Jack, SASS #20451]

I think Lonnie at Run-N-Iron can make just about anything.  At least that has been my experience.

[oak creek martin]

Keep an eye on eBay. There’s a seller on there now that has a bunch of B-SS parts. You might try contacting him directly.

[Dusty Devil Dale]

Sometimes I've found both new and used BSS parts at Numrich, in NY. 

[Johnny Meadows,SASS#28485L]

I found one in excellant condition. Proves that if you get the word out to enough friends, usually something good will happen.

Thanks to all for your help.

JM