Jump to content
SASS Wire Forum

Info needed - .44-40 load using Trail Boss


Quiet Burp

Recommended Posts

I've shot plenty of 6.0 grain TB with a 200 grainer. Great load. (And thanks, Major. :D)

Link to comment
Share on other sites

2 hours ago, Quiet Burp said:

Weird, ADI who make TB don't list a TB load for .44-40?

 

http://www.adiworldclass.com.au/data-rifle/44-40-winchester-44-40-wcf

 

Thanks for the recipes.

They list Trailboss in the "Single Action" section:

 

http://www.adiworldclass.com.au/data-single-action/data-single-action-pistol/44-40-winchester-44-40-wcf

 

Same as Hodgdon (probably where they got their data).

You're welcome.  :)

Link to comment
Share on other sites

13 hours ago, The Rainmaker, SASS #11631 said:

QB, are you able to get TB now or is it left over from better times?

I do know it is (was) made down there.

 

I was very lucky and got 4 kilos (9LB) recently from someone who didn't like using it.

Link to comment
Share on other sites

That link shows 6.5gr max, I always used 6.4gr just because at the time it is what my measure panned out!

Trail Boss creates a low velocity (min) and high pressure (max) for the 44-40 but sure is accurate in my rifle! Great for plinking all the way out to 300 yards...but with one heck of a trajectory LOL!!!

Link to comment
Share on other sites

16 hours ago, The Rainmaker, SASS #11631 said:

QB, are you able to get TB now or is it left over from better times?

I do know it is (was) made down there.

They haven't started making it again yet.

 

You get mixed messages about if or when.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.