Jump to content
SASS Wire Forum

Jackson Rose, SASS #45478

Members
  • Posts

    1,015
  • Joined

  • Last visited

Everything posted by Jackson Rose, SASS #45478

  1. Have your car checked very carefully for mice.
  2. I made one out of a 3/16 nut driver. Cut a slot the proper width and ground the OD to fit my Remingtons. Also opened up the area around the nipples on the Remingtons. So far it has lasted 4 years. Screwdriver handle is easier to handle. If you are careful when filing the slot it will fit better than most nipple wrenches and won't deform the nipples.
  3. I have been loading BP in /on my Dillon, using the stock powder measure since 2008. Run it through my MEC also.
  4. Don't forget affordable health care.
  5. I had my roof replaced 2 years ago. The contractor was recommended by my agent. I upgraded to architectural shingles for not a lot of money. His crew tore off and installed 28 square in 13 hours and cleaned up. The company is in Foristell Mo. If you are interested in him giving you an estimate send me a PM and I will provide you with his number. His original estimate was within $40 of the adjuster's.
  6. Look into the Greene or Warren County areas of Ohio.
  7. My MIL is German. She makes Christmas cookies every year. Her Anise cookies are very light. Most of her cookies are ground nuts held together with meringue with a simple icing. Some like her almond bread are very hard and intended for dunking. Out of the 3 dozen or so I received on Dec. 23rd I have 2 left.
  8. I have a 686-2 with 4 position front sight. Made for the silouhette game. I never adjust the front sight. It is the most accurate pistol I own. My fun gun is a 19 2 1/2 inch barrel. I also used to own Colt revolvers. Prefer S+W.
  9. Just what I needed, a post about chocolate and associated treats. Today is clear liquid day before the roto rooter test tomorrow(routine 10 years since the last one.)
  10. Years ago, RCBS, Lyman, Lee and others standardized shell holders. I find that all of mine from the 3 mentioned brands all work in my old Lyman press.
  11. I use a flipper tray. Then I don't have to handle primers with my hands.
  12. Hi Doc, I thank God every day for the life that we have. Shelly is doing remarkably well. July 29th is the third anniversary of her diagnosis. Planning to attend GOA, looking forward to seeing you again, God bless you and yours, JR

  13. Where do you shoot at Creekside?

  14. PS: you can bend music wire cold with pliers. Cut with a pair of dykes or a dremel with a cutoff wheel.

  15. You need a micrometer, a piece of .041 music wire and a drill press. Knock out the old spring. Drill a .041 (or close) hole going through the slot and .140 into hand.degrease hole and end of wire. Dip end of wire in some JB weld and tap into hole.Let set overnight. Bend and cut to original shape and length. I also used a center punch to peen hole and slot shut. Not hard to do. Good luck Jackson

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.