Jump to content
SASS Wire Forum

Magtech Brass Shotshells


Boolit Boomer

Recommended Posts

What are they under?  I don't see them in shotgun hulls or metallic cases

Link to post
Share on other sites

Shotshell reloading / hulls / brass hulls

 

can also do a search for “brass” on the homepage and that will get you there.

Link to post
Share on other sites
36 minutes ago, El CupAJoe said:

What are they under?  I don't see them in shotgun hulls or metallic cases

I just entered magtech brass in the search on the homepage. Not sure how much they have, but I ordered 12g and 410.

Link to post
Share on other sites
3 minutes ago, Bad Company, SASS #20195 said:

Thanks for the heads-up. Any good sources for reloading these? Thanks.

There is a manual for sale on the same page as the brass hulls.

Link to post
Share on other sites
1 minute ago, Bad Company, SASS #20195 said:

Thanks for the heads-up. Any good sources for reloading these? Thanks.

No sources. I load them the same way I load BP in the plastic hulls. Except for the crimp. I use hot glue to hold the overshot card in place. These brass shells do require 11 gauge wads and cards to seal properly as the walls are thinner than the plastic hulls.

Link to post
Share on other sites
1 hour ago, Bad Company, SASS #20195 said:

Thanks for the heads-up. Any good sources for reloading these? Thanks.

 

Here is how I do it. 

 

 

 

I have upgraded my priming by using an RCBS 12 gauge shell holder and Lee priming post.

 

5a8c7fe27bb7e_Prime12gaugebrasshullsFeb2018.jpg.d4569f1d8625a86e8d8c6b1890b8e914.jpg

Link to post
Share on other sites

The local toy store has some in stock most of the time.  He's got 12,16,20,  I'm not sure if he has .410

Link to post
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.