Jump to content
SASS Wire Forum

Clay Dot versus Clays


Old Ranger

Recommended Posts

Posted

Came upon some Clay Dot couldn’t find any Clays, can I use same reloading data for  my 12 gauge , 7/8 oz (#7.5 shot),Win AA hulls, Win 209 primers , Claybuster Wads, ( Grey)?

Posted

Clay -Dot isn't  quite as hot as Clays.I increased  my charge by about 10% over  Clays.

Works fine,no problems.

Posted

Use exactly the same setting with Clay Dot as I did with Clays.  Can't tell any difference in my cartridge or shot shell loads.  It just works.

Posted

There should be shot shell data listed by the manufacturer for Clay Dot, but I do agree with Choctaw Jack above in that Clay Dot doesn't seem to be quite as hot as Clays.  However, It is indeed very similar and using the same load and components that worked with your Clays loads should work just fine and the difference would be hard to even notice.  If you have a variable charge bar, then you could bump it up a bit if you want, but I wouldn't spend the money for another powder bushing just to load Clay Dot instead.  Good luck and good shooting to all.  

Posted

I loaded the same as Clays and never noticed a difference. I didn't crono the loads, but they were close enough that I couldn't tell the difference.

J.M.

Posted

Clay Dot is slightly bulkier than Clays, but has the same usage by weight. I remember going up one MEC bushing when I switched a while ago. Then went back to Clays after I found some available. 

Posted
On 8/6/2021 at 8:29 PM, Old Ranger said:

Came upon some Clay Dot couldn’t find any Clays, can I use same reloading data for  my 12 gauge , 7/8 oz (#7.5 shot),Win AA hulls, Win 209 primers , Claybuster Wads, ( Grey)?

I load with a MEC and use a 27 bushing for Clays, Red Dot and Clay Dot without any problems.  For .38 special I had to increase my load by .2 to keep primers from backing out with Clay Dot.

 

Randy

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.