Dillon 550 lighting kit, interesting

[Three Foot Johnson]

The first I've ever seen of this. I think it might be a bit better with the power plug mounted on the other side so it pointed up, but other than that, it looks like a great idea.

 

https://reloadinginnovations.com/collections/led-reloading-press-lights/products/starlight-press-lighting-system-for-dillon-550

 

I don't know why he has .357 on his .45-70 tool head...

[Hardpan Curmudgeon SASS #8967]

51 minutes ago, Three Foot Johnson said:

The first I've ever seen of this. I think it might be a bit better with the power plug mounted on the other side so it pointed up, but other than that, it looks like a great idea.

 

https://reloadinginnovations.com/collections/led-reloading-press-lights/products/starlight-press-lighting-system-for-dillon-550

 

I don't know why he has .357 on his .45-70 tool head...

 

 

Great great great great grandson of Josh Randall...?  

[Badlands Bob #61228]

They sell them for 650's too.  Neat idea but I would need a light kit for each tool head.  That would get expensive.

[Hillbilly Drifter]

here is the option I chose. It works with all your tool heads as it slides into the center hole. works well. 

http://www.uniquetek.com/product/T1669

[Three Foot Johnson]

1 hour ago, Badlands Bob #61228 said:

They sell them for 650's too.  Neat idea but I would need a light kit for each tool head.  That would get expensive.

Not the whole kit, just the LED circuit board module. $22.32 apiece in the 3 packs - $28.65 for the 650. Less than a decent 1911 magazine for Wild Bunch.

[Silvertip]

Look at Inline Fabrication 

ST

[Three Foot Johnson]

Whoever makes them, the Uniquetek and Inline Fabrication are the same lighting system.

[The Original Lumpy Gritz]

5 hours ago, Hillbilly Drifter said:

here is the option I chose. It works with all your tool heads as it slides into the center hole. works well. 

http://www.uniquetek.com/product/T1669

 

I've use this one, since they first came out-great product and doesn't block access to the cases.

OLG

[Red Eye Jim]

6 hours ago, Hillbilly Drifter said:

here is the option I chose. It works with all your tool heads as it slides into the center hole. works well. 

http://www.uniquetek.com/product/T1669

 

This is the one I installed as well.  Works nice.