Single Six in .32 H&R

[Hashknife Cowboy]

Made in 2001, I have a Single Six in .32 H&R that is in need of grips.  It is a 4  5/8th's barrel gun  in stainless.  The grip frame is shorter than the newer Single Six so can someone recommend a grip maker that doesn't break the bank?

 

 

[Hardpan Curmudgeon SASS #8967]

Can't help ya, HC, but I will say that that is a right handsome li'l revolver.  

[Kid Rich]

I might have a couple of those layin' around, I'll check and get back to ya.

kR

[Kid Rich]

All I have are the grips that are the same size as the OMVs. If that is what you have I can probably round up a set.

kR

[Widder, SASS #59054]

I was faced with a similar dilemma so I took a 'larger' pair of grips and cut the bottom off to fit the frame.

 

Just make sure the 'stud and hole' match up before you cut or trim the larger grips down to the smaller size.

 

 

..........Widder

 

[Sgt. C.J. Sabre, SASS #46770]

Try this guy. https://www.tombstonegrips.com/mm5/merchant.mvc?Screen=PROD&Store_Code=TGG&Product_Code=Ruger_104a&Category_Code=Ruger

He has grips for almost anything.

[Boulder Canyon Bob# 32052L]

I bought a pair for my wife's from Arizona custom grips on EBAY.

https://www.ebay.com/str/arizonacustomgrips