Deuce Stevens SASS#55996 Posted January 10, 2018 Share Posted January 10, 2018 Probably a long shot but does anyone know the thread pitch of the screw for the right cartridge guide of a Rossi 92. Thank you. Link to comment Share on other sites More sharing options...
Jackrabbit Joe #414 Posted January 10, 2018 Share Posted January 10, 2018 Yo Deuce try M&M guns ( Mike) at (703)739-2150 or (571)276-7676. I do know that the thread is very fine on the cartridge guide. Hope this helps. Deuce also finally found (Steve) Rossi 92 Specialist at stevesgunz.com. (aka)Nate Kiowa Jones. Jackrabbit Joe #414 try 5/32 down to 3/32 the screw for the load gate is a little smaller. Link to comment Share on other sites More sharing options...
Blue Eyed Drifter Posted January 10, 2018 Share Posted January 10, 2018 Deuce When I lost the One on my 92. Cannon Replaced it with a 73 Lever Spring because the Screw i from Chippa did not fit. the 73 work Great Blue eyed drifter Link to comment Share on other sites More sharing options...
The Original Lumpy Gritz Posted January 10, 2018 Share Posted January 10, 2018 Might be worth a call to Brownells, and a word with their 'tech' folks. PLZ let us know what you find out as I bet it is metric of some type. Good luck, OLG Link to comment Share on other sites More sharing options...
Flint N. Steele Posted January 12, 2018 Share Posted January 12, 2018 I had one stripped (left cartridge guide) and it got tapped to the next size, with a steel screw. The Rossi stainless screws are *soft.* Link to comment Share on other sites More sharing options...
The Original Lumpy Gritz Posted January 12, 2018 Share Posted January 12, 2018 Hey OP. Any updates? OLG Link to comment Share on other sites More sharing options...
Smokestack SASS#87384 Posted January 13, 2018 Share Posted January 13, 2018 Just pulled mine and measured it. My eyes are not too good, but I’m fairly certain it’s an M3.5x .35 Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.