Jump to content
SASS Wire Forum

IAC 97 wood replacement

Rootin Tootin

Recommended Posts

Forearms have a couple of configurations (three screw holes being one) and will be a problem unless you are really good at knowing your 97s. Your IAC does not use the three-screw type of forearm.


Buttstock - most likely will fit.


BUT - current production 97 clone wood is available from Coyote Cap. coyotecap.com

I'd go that way, and get really nice walnut already finished, and no chance of a forearm disaster.


Good luck, GJ

Link to comment
Share on other sites

The sile should fit. I installed one on a 09 IAC. Some may require a rat tail file to open the inlet hole for the receiver shank.

Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Create New...

Important Information

By using this site, you agree to our Terms of Use.