Charlie MacNeil, SASS #48580 599 Posted November 23, 2019 Does anybody load these? A good friend has asked me to load some with Speer shotshell capsules but I’m not sure how to go about it. Help? Share this post Link to post Share on other sites
BLACKFOOT SASS #11947 385 Posted November 23, 2019 I remember there being basic instructions on the box. If more information is needed try the Speer web page. Blackfoot Share this post Link to post Share on other sites
Rowdy Ranger Rick 26 Posted November 23, 2019 There were a couple threads a couple years back that discussed this on the SASS Wire, relative to snake control...I couldn't locate the threads though. Load data and instructions are included with the Speer shot capsules... https://www.midwayusa.com/s?userSearchQuery=speer+shot+shell&userItemsPerPage=48 Here's a good video... I made some in .45 LC and .44 Mag. with both milk carton shot cards as cap and glued, and a gas check as the cap. Both were roll crimped. There are several YouTube videos showing this. Here's one... RRR Share this post Link to post Share on other sites
The Original Lumpy Gritz 6,243 Posted November 23, 2019 Be very careful when seating and case mouth crimping. Those plastic capsules crack easily. I get my best results using Unique powder. OLG Share this post Link to post Share on other sites
H. K. Uriah, SASS #74619 729 Posted November 23, 2019 I have had good success by filling the capsule with shot, and then using the Trailboss "Formula" to determine how much powder to put behind the capsule, which I treat as if it were a bullet. Share this post Link to post Share on other sites
Charlie MacNeil, SASS #48580 599 Posted November 23, 2019 Thanks, folks! Share this post Link to post Share on other sites
Crisco 44 Posted November 23, 2019 I will just add that the smaller the shot, the better they will perform out of a pistol. If you can find a few ounces of #12 you will be impressed by how they work. Share this post Link to post Share on other sites
Imis Twohofon,SASS # 46646 1,551 Posted November 24, 2019 I have loaded them for a 10 1/2 in SBH when I owned a snake haven in the country. Works well, instruction on the box Imis Share this post Link to post Share on other sites
Charlie MacNeil, SASS #48580 599 Posted November 24, 2019 Thanks! Share this post Link to post Share on other sites
