Jump to content
SASS Wire Forum

SGT. ELI 35882 GUNFIGHTER

Members
  • Posts

    1,725
  • Joined

  • Last visited

About SGT. ELI 35882 GUNFIGHTER

  • Birthday 05/25/1959

Previous Fields

  • SASS #
    35882 LTG Regulator
  • SASS Affiliated Club
    Marion County Renegades~Lakewood Marshals~Dooley Gang

Profile Information

  • Gender
    Male
  • Location
    Southern Illinois
  • Interests
    Guns,Western and Military history,Hot Rods, Motorcycles

Recent Profile Visitors

9,212 profile views

SGT. ELI 35882 GUNFIGHTER's Achievements

SASS Wire Vet

SASS Wire Vet (1/1)

161

Reputation

  1. Small tool which compresses and holds the loading gate spring allowing you to push the trigger/bolt pin in and out with ease during disassembly/reassembly.
  2. A bunch of small caliber lightened 66/73 carriers, '97 wire springs, ruger helper tool, possibly 8 lb. of sport pistol.
  3. The 45 receivers also have a cut out in bottom where bolt lower tab passes thru, 357 receivers don't.
  4. It's whatever you're comfortable with. I prefer the rhythm of single cocking. One of the fastest gunfighters around singles.
  5. I have milled a flat and installed a shotgun bead on some
  6. Beware of factory "competition ready" guns as they rarely are. The Winchester is way better out of the box, but the parts thing is a drawback. If you decide Winchester, call Cowboy Carty. Otherwise I eould advise buying a standard Uberti in barrel configuration you want and hand it to a cowboy smith and have it properly set up
  7. Thank goodness, I thought I was going to have give Big 6 some cash
  8. He lives in Paducah, Ky. If I see him tomorrow I will tell him to contact you
  9. I use my mill and mill vise and either 3/16 or 1/4 cratex.
  10. I do stainless mag tubes, but after searching high and low have never been able to find the correct size short of custom made($$$). The ones I do are slightly undersize and I fit them to the rifle.
  11. And the full length firing pin has a spring that pushes the firing pin forward to be in contact with the primer.
  12. The best tool I have seen was custom built with replacable carbide cutters. The tool was about $1500. I don't even mess with doing them anymore. I just take them to the man with the tool .
  13. Best I can do, not in the shop today. https://www.securefirearmproducts.com/Model_Details.php?modelno=11490-SR-D
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.