Jump to content
SASS Wire Forum

trailer hitch question


Trigger Mike

Recommended Posts

a friend bought the new Jeep Renegade and had the dealer install a towing package. Instead of using Jeep parts and replacing the bomber with the one with a hole in it for the hitch the dealer installed an aftermarket under the number so it sits low. They are concerned their trailer will not sit right. I suggested they get a ball mount that has the ball higher than the part that goes into the towing package. Am I right? are all towing holes the same diameter square or is there anything I am missing? I apologize for my ignorance .

Link to comment
Share on other sites

i do not know, i better ask the dealer what they installed as my friend does not know

It will be marked on the hitch.

With the trailer loaded up along with the tow 'pig' fully loaded. You want the trailer to be level, to no more than 1 inch low at the hitch.

Is this a load-equalizer hitch?

I suggest your friend had better learn more about towing. ;)

OLG

Link to comment
Share on other sites

And, maybe take the jeep back and have them remove their parts, replace with his old parts and refund his $. Then, he can go to a trailer house, learn what he needs and have th sell and install one specific to his needs.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.