Jump to content
SASS Wire Forum

Hammer Switch


Two-Bit Charlie

Recommended Posts

Posted

I have a new model Blawkhawk in 45 Colt that I got for hunting. I'm having a hard time reaching the hammer with the thumb of my shooting hand after I installed the Houghe rubber grip. Can I replace the Standard Blackhawk hammer with the Bisley Blackhawk hammer?

 

Two-Bit Charlie

Posted

not without changing the trigger too. try and find a Super Blackhawk hanner

I thought that you could change out just the hammer on a Ruger. Not that it would be legal for SASS.

Posted

:FlagAm::FlagAm::FlagAm::FlagAm::FlagAm:

 

You can put in a Super Blackhawk or Bisley hammer without trigger changes.

I would actually go for a SBK over a Bisley in your case.

He's got a Hogue grip and using it for hunting, not SASS.

 

Check to make sure the hammer you decide on will not interfere with the backstrap relief cut, though.

 

MG

Posted

Thanks for the help guys. The problem I'm having is reaching the hammer with the new grips. So is the Super Blackhawk hammer lower and easier to reach than the standard Blackhawk hammer?

 

Two-Bit Charlie

Posted

Thanks for the help guys. The problem I'm having is reaching the hammer with the new grips. So is the Super Blackhawk hammer lower and easier to reach than the standard Blackhawk hammer?

 

Two-Bit Charlie

 

Yes

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.