Knarley Bob Posted September 20, 2011 Posted September 20, 2011 Is there a better way to get the extractor out without using a BFH and a drift punch? The gunsmith is 30 miles........ one way. Thanks, Knarley
Badger Mountain Charlie SASS #43172 Posted September 20, 2011 Posted September 20, 2011 Is there a better way to get the extractor out without using a BFH and a drift punch? The gunsmith is 30 miles........ one way. Thanks, Knarley Talk to Willie Wheelgun. He took his out.
The Original Lumpy Gritz Posted September 21, 2011 Posted September 21, 2011 Is there a better way to get the extractor out without using a BFH and a drift punch? The gunsmith is 30 miles........ one way. Thanks, Knarley Well.....That's how Marlin put the bugger in It NOT hard to DIY Cheers, LG
Count Sandor, SASS #74075 Posted September 21, 2011 Posted September 21, 2011 Hey Knarley: The extractor should be driven out from the bottom of the bolt to the top - use a chunk of wood with a hole to receive the pin. Unless someone has already taken the pin out and driven it in from the other side, its not all that difficult. There will be a bunch of crud to clean out of the well where the extractor lives. The hardest part of the job is aligning the new extractor with the pin hole and keeping it aligned while you insert the pin...Of course, maybe any advice from me on that particular Marlin should be taken with a grain of salt...!! Count Sandor
Badger Mountain Charlie SASS #43172 Posted September 21, 2011 Posted September 21, 2011 That is about the way I heard it, Count.
Recommended Posts
Archived
This topic is now archived and is closed to further replies.