The Original Lumpy Gritz

Call them... They make everydangthing in house and the extractor 'hook' is very complex to make. Maybe, if enough folks call, they'll reconsider making them.

You're short stroking the action

Yes, spring may have taken a set. You can call Wolff Gunsprings and order the uncut springs. Just tell'em it's the springs they sold to RPP. FWIW; I never remove the extractor for cleaning. I flush it with spray carb cleaner and then spray lube into it and blow it out with compressed air.

They bought their springs from Wolff Gunsprings. Call RPP and see if they have any springs left. Flush out the extractor channel with carberator cleaner. You'll be surprised how much crud is in there.

Did your extractor come with 2 different length springs?

Told me, they didn't sell enough of'em. I was very surprised when I was told this!

You want more spring tension. I learned this, when I was doing the prototype testing of the extractor for RPP.

Is there another range you could shoot at? Do you have a link to the club in question? IMHO, sounding like they want you gone...

Add some heat. To lap the bore, use a jag and a tight fitting cotton ball with lots toothpaste on it..

FYI, HP-38 is the same as WW231

Very carefully

TNX!

Where did you buy it?

Do you use a firm roll-crimp? I use 4.0gn w/158gn RNFP in .38 Special for my wife's SASS loads.

Lap the bore! You may want to recut the muzzle crown.

Old E in 2F

WW231/HP-38 What's your load.

Check all screws for tightness, again. May have to shim the left feed rail.

RPP no longer make that extractor

Because we don't like you

SASS level loads will be fine. Load 10 rnds, and do a live fire test.

Silicone spray

ABOUT DAMN TIME!

Put this in the Classifieds too

What part of Missouri are you in? I'm located in SW Springfield.....