Jump to content
SASS Wire Forum

WTS Uberti '66 .44 sp. short rifle parts REVISED


el Pueblo

Recommended Posts

Posted

Selling used Uberti  '66 .44 sp. short rifle parts , manuf circ. 2001, component groups as listed below., EXCEPT NO RECEIVER.

$525 takes ALL, incl. shipping CONUS, or individually as priced below.

  1. Octagonal .44 sp. 20'' barrel, bright bore, speed front sight, mag tube with SS spring and follower.............................................................................$200
  2. Wood forestock, brass end cap  w/ screws and spacer (10 years' worth of dings as main match gun)…………………………...…….................................…...…$95
  3.  Right and left side plates w/ screws, good loading gate......……...$80
  4. Hammer/trigger assembly ….....................………………………………………………….$60
  5.  Wood straight-grip buttstock with brass butt plate and screws (dings as in 2. above)……………………………...…...…...……………………................................……..$175

uberti 66 all 1.jpg

Uberti 66 Num.jpg

Posted

If you'll consider $300 shipped for everything listed above, I'll take it. This offer isn't meant to be offensive, but I've paid $700 for used, complete and working 66's in the past. I'll completely understand your passing on this offer.

Thank you for your consideration.

Tully

Posted

I'd be interested in everything in front of the receiver if you decide to break it up a bit more. Makes no sense for me to buy a damaged receiver when I will have to pay another 100+ dollars to run it through an FFL.

Posted

Slim,

I'm not knowledgeable enough to separate the receiver from the barrel

without damage. Respectfully, I wasn't aware an inoperable receiver with no links, lifter, carrier, lever, would have to go through an FFL.  Am I missing something?

Posted

Any receiver with the serial number has to go through an FFL, Unless it has been demilled. Not sure of what that procedure entails, but don't think you can just saw it in half and call it good.

Posted

Goody, thanks for your reply and knowledge.

I'll figure out a way to get the damaged receiver off the barrel/mag tube to make a sale 

easier.

Posted
15 hours ago, Springfield Slim SASS #24733 said:

I'd be interested in everything in front of the receiver if you decide to break it up a bit more. Makes no sense for me to buy a damaged receiver when I will have to pay another 100+ dollars to run it through an FFL.

For $250.00 more you can buy my 66 a whole one that works ??

Posted

As an aside I don't know why a good machinist couldn't bore that hole oversize and put a steel bushing in there.

Posted

Or a brass bushing, as the pin usually turns in the hole.

Posted

Slim, Goody, et al...............................Thanks for the input.

RECEIVER HAS BEEN REMOVED.

Balance of parts for sale as listed revised, WITHOUT RECEIVER.

 

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.