LQ Jones Posted January 11, 2021 Posted January 11, 2021 Here's an interesting one. Bob Millington thin plate conversion on a Pietta steel frame repop, defarbed. .32 S&W short or long. Super tight; I've only shot it a few times and I got it years ago. No BP cylinder; useless anyway Not sure if Bob is even still doing conversions. reduced - Asking $775 shipped to FFL.
Fireball #7709 Life Posted January 12, 2021 Posted January 12, 2021 Will 327 Federal fit? Asking for a friend
Gimmyguns Posted January 17, 2021 Posted January 17, 2021 Would you consider trading this? Thank you gimmyguns
LQ Jones Posted January 17, 2021 Author Posted January 17, 2021 13 minutes ago, Gimmyguns said: Would you consider trading this? Thank you gimmyguns PM sent.
Muley Gil SASS # 57795 Posted January 17, 2021 Posted January 17, 2021 On 1/12/2021 at 10:30 AM, Fireball #7709 Life said: Will 327 Federal fit? Asking for a friend Lord I hope not! I believe the pressures would be too much. Even the conversion cylinders for the Ruger Old Army state that they are rated for nothing hotter than cowboy loads
Fireball #7709 Life Posted January 17, 2021 Posted January 17, 2021 6 hours ago, Muley Gil SASS # 57795 said: Lord I hope not! I believe the pressures would be too much. Even the conversion cylinders for the Ruger Old Army state that they are rated for nothing hotter than cowboy loads The cylinder isn't long enough, it was a joke.
LQ Jones Posted January 19, 2021 Author Posted January 19, 2021 btt On 1/17/2021 at 6:03 AM, Fireball #7709 Life said: The cylinder isn't long enough, it was a joke.
Recommended Posts
Archived
This topic is now archived and is closed to further replies.