Jump to content
SASS Wire Forum

Archived

This topic is now archived and is closed to further replies.

Rancho Roy

DIY...Portable Shooting Bench

Recommended Posts

I've been inundated with requests for the plans for my "Swivel Top - Portable Shooting Bench"...So to make it easier for folks I wrote a short article complete with dimensioned drawings on my web site.

 

Hope you enjoy it!

 

http://rvbprecision.com

Share this post


Link to post
Share on other sites

Howdy,

Thank you, that is one very nice shootin bench.

For years Ive been using its more primitave cousin.

Mine is just a rectangle, take a 4x8 sheet of plywood about 1/2 thick

and cut it lengthways and cut the halves in thirds.

This give six equal sized tops.

Buy folding leg set and attach to the bottom like a typical folding table.

The problem with this is that the legs dont fold up flat, one is flat

and one is sticking up a little. What I did to minimize loss of space is

I set army ammo boxes onto the bench after putting the folded bench in

the trunk upside down. This way the ammo boxes are not sliding around

and a fairly flat surface is ready for luggage.

Your idea of a single rear leg is something I might have to try.

My little bench is much simplier and has been used for all sorts of non

shooting things.

Yours is more specialized, very interesting.

Thanks

CR

Share this post


Link to post
Share on other sites

You're more than welcome......................

 

There are always many ways to skin a cat!

Share this post


Link to post
Share on other sites

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.