Jump to content
SASS Wire Forum

Archived

This topic is now archived and is closed to further replies.

Pulp, SASS#28319

'92 cartridge lifter

Recommended Posts

I got the Nate Kiowa Jones video and spring kit for Christmas. Took my ol Rossi apart, smoothed it up per instructions and am attempting to put it back together. Once it's together the cartridge lifter won't lift the cartridge enough to allow it to chamber. Tried twice now, still won't lift. What am I missing? There are two grooves on the left side of the receiver, below the cartridge guide, and I'm assuming the little spring loaded pin on the lifter snaps into the bottom groove, at least it looks level that way.

 

Any tips or hints? I'll call Nate tomorrow if'n I don't get it right tonight.

Share this post


Link to post
Share on other sites

Check to see if your left cartridge guide is seated all the way...sometimes the cartridge stop joint pin gets out of place and doesn't allow the guide to seat all the way.

Which in-turn will bind the lifter not allowing it to left all the way.

 

BH

Share this post


Link to post
Share on other sites

Call him but wait until about noon as he is a nite owl. He will have you up and going in a matter of minutes.

Share this post


Link to post
Share on other sites

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.