J. Frank Norfleet Posted December 4, 2021 Posted December 4, 2021 I've had this for 2 yrs and never used it. I did try it on and put pistols in the holsters so there is some scuffing. These were made for Ruger single-six pistols with a 5.5 inch barrel. The holsters are longer than the pistol barrels as you can see in the photo with my pistols. So with a 4.5 inch barrel there is extra holster. Loops on the belt are 32 H&R. Belt is heavy double leather; 3 inches wide and 42.5 from the buckle to the center hole. If you replace the chap buckle with a trophy buckle you can gain a bit depending on your buckle. This was made by DAD Custom Leather so it was probably made in Mexico. $200 shipped to CONUS. First I'll take it here gets it. And, no the pistols aren't included. JFN
SouthwestShooter Posted December 4, 2021 Posted December 4, 2021 damn fine rig. if I bad just ordered a set from mernickle I'd snatch them up. good luck.
Noruego Fisk Posted December 5, 2021 Posted December 5, 2021 will the loops fit 38spl? and will the holsters fit 357/38 piettas 4.75"? sorry for the questions I'm new to sass. Thank you
J. Frank Norfleet Posted December 5, 2021 Author Posted December 5, 2021 6 minutes ago, Piscado said: will the loops fit 38spl? and will the holsters fit 357/38 piettas 4.75"? sorry for the questions I'm new to sass. Thank you No the loops are too small for 38s. The single six is a small framed revolver. I doubt if any Piettas will fit. Would have to be small framed like a Cimaron P. JFN
Noruego Fisk Posted December 5, 2021 Posted December 5, 2021 alright. thank you for getting back to me and letting me know. good luck to you.
Flat Top Okie Posted December 5, 2021 Posted December 5, 2021 Hello J. Frank, I will take the rig if it is still available. Tell me where to send the money. Flat Top Okie
J. Frank Norfleet Posted December 5, 2021 Author Posted December 5, 2021 PM sent. SPF to Flat Top Okie JFN
Recommended Posts
Archived
This topic is now archived and is closed to further replies.