Buckshot Bear Posted November 4, 2021 Share Posted November 4, 2021 My Lee Bench Prime arrived yesterday......Jeez I wish I'd had one of these years ago to save my hand using the old hand held one for decades. I plagiarized a mod I saw elsewhere by drilling and tapping for a 4mm set screw to stop the shell plate holder moving around like it had same on the hand held one. Only difference with my mod is that I drilled and tapped both sides so I could exactly center the primer punch. Link to comment Share on other sites More sharing options...
Dutch Wheeler Posted November 5, 2021 Share Posted November 5, 2021 Nice, modification, I like that idea! Make sure these screws are good and snug, otherwise you might have a jam. Link to comment Share on other sites More sharing options...
watab kid Posted November 6, 2021 Share Posted November 6, 2021 i like that as well , started out priming with the press - very unsatisfactory , went to the hand primer - its a huge improvement , this bench mounted unit would be something id like to try , Link to comment Share on other sites More sharing options...
Buckshot Bear Posted November 6, 2021 Author Share Posted November 6, 2021 10 hours ago, Dutch Wheeler said: Nice, modification, I like that idea! Make sure these screws are good and snug, otherwise you might have a jam. There was half a turn in them both, thanks Dutch. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.