Jump to content
SASS Wire Forum

Tang sight adjust?


Timber Rattler

Recommended Posts

Posted

Now stop laughing!! I have a Lyman #2 tang sight and no instructions (dangerous) I loosened the set screw and pulled out the barrel and eye piece but cannot get the barrel to turn(does it?). I need to lower the sight.

Thanks

Posted

You weren't supposed to remove any screws or pull out the eye piece. The barrel just turns and the sight staff goes up and down. Here's an excerpt from the instructions.

 

"To adjust the sight for elevation, turn both knurled sleeves at the same time. Turning

the sleeves clockwise will raise the sight, counter-clockwise will lower the sight.

Once the correct elevation is found, turn the sleeves in opposite directions so they

lock against each other. This will lock the elevation post in place and

prevent any movement."

Posted

I am quoting this from Lyman's instructions,"To adjust the sight for elevation, turn both knurled sleeves at the same time. Turningthe sleeves clockwise will raise the sight, counter-clockwise will lower the sight. Once thecorrect elevation is found, turn thesleeves in opposite directions so they lock against each other." Also they say DO NOT attempt to loosen the set screw that holds the elevation pod together. Not the end of the world, mine was loose as it came from Lymans. Finding something small enough to fit it to tighten it is the only problem. Lymans toll-free no. is 1-800-22-LYMAN. Hope this helps.

Posted

Thanks, it was froze tight with a little rust (just got it used,my first) but it has loosened up.

Thanks for the help!

 

Hit with a drop of Breakfree CLP, then work it back and forth to the full length of travel.

 

Ride easy, but stay alert! Godspeed to all those still in harm's way in the defense of Freedom everywhere! God Bless America! :FlagAm:

 

Your Pard,

Posted

Hit with a drop of Breakfree CLP, then work it back and forth to the full length of travel.

 

Ride easy, but stay alert! Godspeed to all those still in harm's way in the defense of Freedom everywhere! God Bless America! :FlagAm:

 

Your Pard,

:angry: Make sure that little set screw is tight I had one come apart and hit me in the safety glasses left a mark in the lense . Woodfox

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.