Cholla Posted February 27, 2021 Share Posted February 27, 2021 I bought a broken US Revolver in .32 S&W two years ago and after much procrastination I decided to replace the faulty trigger reset spring. Despite my best efforts I can't get the trigger to reset. In the process I thought maybe the trigger was just too gritty to allow the spring to work properly... so I removed it and wasn't fast enough to document how the sear spring went. 1. How does the sear spring fit into the assembly - See photo. It doesn't seem right as installed. 2. How do I get the reset to work properly? I found one bit of information that said the screw that goes through the frame into the trigger guard sets the spring pressure. I assumed more pressure is better but maybe I'm wrong. I can't check until I get the sear spring thing figured out. I have watched every Youtube video I could find and they either don't go that deep into the pistil assembly process, bleep over that part of the process, or cover a different style of trigger assembly. Link to comment Share on other sites More sharing options...
Ron "Ironhead" Smith Posted February 27, 2021 Share Posted February 27, 2021 Try the short leg of the spring in the big notch on the other side of that part. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.