Boondock Saint, #70146 Posted December 31, 2010 Posted December 31, 2010 My lovely wife presented me with a Redwing Screwknife as a Christmas present. The sheath that accompanied the knife has a square "flange" on the back of it. Is this intended to be a compression fit between the belt and the holster, or do I need to somehow thread it to the belt or the holster? My holster skirt has a couple of chicago screws in it. I thought I would just punch a couple of holes in the flange to match the pattern on the skirt, but I thought I would seek out some advice before I started punching any holes. Thanks, Boondock
Red River Ray SASS#33254 Posted December 31, 2010 Posted December 31, 2010 You got it buddy! screw er on. RRR
Oklahomabound Posted December 31, 2010 Posted December 31, 2010 I attached it with thread at the top & bottom of the leather flange-
Gold Canyon Kid #43974 Posted December 31, 2010 Posted December 31, 2010 Redwing attached mine with Chicago screws to rear side of my strong side holster. He used one existing screw in the holster for bottom and added one new one for top.
Go West Posted December 31, 2010 Posted December 31, 2010 Rivets, screws, or thread, it's up to you. Put it in an easy access place since you may want to use it for clearing a jam on the clock.
Kid Ziggy SASS 76870 Posted December 31, 2010 Posted December 31, 2010 Boondock, If you take the knife out when you mark your drilling holes, make sure you allow some room for the handle and leave room to draw the knife. I use mine most when shooting cap & ball.
Recommended Posts
Archived
This topic is now archived and is closed to further replies.