Fireball #7709 Life Posted February 18, 2020 Share Posted February 18, 2020 Just a heads up. Verify your extractor pin size before ordering extractors from Taylors parts department. They're shipping extractors that have a 5/64" hole in them, I have yet to see a bolt with that size pin hole, all I've seen are 1/16", but not having any newer generation Uberti 73's on hand, I can can only surmise they made a change. When I called, Taylors doesn't know anything about a running change, and when I asked if I was stuck with these, the answer was yes. Maybe I can fit them to a Miroku, they have a larger pin For those that are going to tell me about the aftermarket ones available, I know and I appreciate that, however my application doesn't require the more expensive aftermarket part. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.