RIP McGaw, SASS # 54921 Posted November 15, 2011 Posted November 15, 2011 Does anyone have plans for a tombstone rack - the one at DS welding looks good but I don't think it will fit in my suitcase on the way back from Winter Range to OZ thanks in advance RIP McGaw
Three Foot Johnson Posted November 15, 2011 Posted November 15, 2011 Ya just need 5 plates, each one slightly smaller that the one in front of it, hinge 'em to a rack, put some legs on it, and yer set to go. Make sure they're far enough apart so they don't domino! I think I started out with 14" tall x 10" wide on mine, then dropped 15% or so each way on the four successive plates... maybe it was 20%... I don't remember. 20% = 14" x .8 = 11.2" x .8 = 8.96" x .8 = 7.168" x .8 = 5.7344" 10" x .8 = 8" x .8 = 6.4" x .8 = 5.12" x .8 = 4.096" That sounds about right, my last target is pretty dang small.
Recommended Posts
Archived
This topic is now archived and is closed to further replies.