-
Posts
985 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Posts posted by Stump Water
-
-
16 hours ago, Hardpan Curmudgeon SASS #8967 said:
I stumbled upon this one, which might bear consideration: "Old School Garage Latch"
Not sure what the extra handles and stuff is for with that kit.
Try this one.
-
On 4/22/2024 at 7:50 PM, Tennessee williams said:
Now it's a whole other story if you're wanting your stage times to improve. The indisputable best way to get lower stage times is get faster at what you're doing when you're not pulling the trigger. There's no secret speed sauce. Cut down on the time it takes between trigger pulls.
Exactly. And the low-hanging fruit is the shotgun. SG is the only gun we load on the clock. Git gud at loading the SG.
- 5
-
-
All in the Family couldn't be aired today.
- 4
- 1
-
Now I'm going to have to dig out the civil war records of my great grandfathers that my dad "sent off for" many years ago.
-
3 hours ago, Red Gauntlet , SASS 60619 said:
The big thing we did there was rope swings; when you swung out all the way, you were 75-100 feet above ground. If you fell, you'd die. So you held onto the rope and didn't fall
When the contractor built the "neighborhood" (one dead end road with 16 houses) they ran 12/3 for temporary power in the trees behind the construction sites. There was a big ravine behind the houses across the street. We found a remnant of the temp power line and used it to get a good running start and swing out way over the ravine.
Then one day we climbed the tree the line was in and found it attached by one staple.
- 1
-
19 hours ago, watab kid said:
the islands campaign was a brutal episode in history
Indeed. For a glimpse into the brutality read James Bradley's other book Flyboys.
ETA link... https://en.wikipedia.org/wiki/Flyboys:_A_True_Story_of_Courage
- 1
- 1
-
-
On 4/16/2024 at 9:35 AM, Cemetery said:
It was explained, and shown to me years ago. When you pull the hammer back with your thumb, and hold it, the cylinder slightly over rotates, thus potentially throwing the alignment off the firing pin and primer enough to get light/no hits on the primer.
Forget the trigger. Can you explain how pulling the hammer back and holding it is different than pulling the hammer back and not holding it?
IOW... with your booger hook nowhere near the trigger, pull the hammer back and hold it. What happens when you take your thumb off the hammer? Does the cylinder un-over-rotate? If the answer is "yes" then your pistols need some work.
- 2
-
A pair in 45C w/5.5 bbl.
A pair in 45C w/4 7/8 bbl w/BH grips.
A pair in 357 w/5.5 bbl
A pair in 357 w/5.5 bbl w/Ruger's version of Bisley grip frame.
All have free spin, springs, etc.
The Bisleys have everything Wes Flowers could do to them.
- 1
-
Yeah. That's not the same.
-
Hop Sing.
- 2
-
Brother Dave
-
I have a reloading log. In it I log what I load... bullet, powder, OAL, the usual stuff.
For handguns, unless there is a problem, there are no notes.
For long guns I note accuracy. Once I have arrived at a load that works in a long gun that's pretty much it - that's what I load for it forevermore.
For example: The Rem. 700 Classic in .243 Win likes an 87 gr. Hornady BTHP with [can't remember right now] grains of H4831 with an OAL of [can't remember right now]. That's what I load for it. Period. It works. SW Va. groundhogs agree.
- 1
-
The front shoulders & head of boars are a lot bigger than sows. If you see them in a bunch there will be no doubt which is a "mature boar".
ETA: Think of it like this... in a herd of polled Herefords or Blank Angus cattle you can tell which one is the bull.
- 1
-
And the Romans long before that.
-
The Terminator movie. Does it happen over and over or only once?
-
Nice looking irons.
- 1
-
47 minutes ago, Marshal Mo Hare, SASS #45984 said:
About 1900?
QuoteThis photograph is an interesting footnote to the history of the infantry square, it shows US troops demonstrating a company strength hollow square formation to be used to combat unrest in urban areas, c.1918.
-
I'll try to make it to the CAGS this weekend.
(Cowboy Action Gun Shoot)
-
On 4/5/2024 at 2:05 PM, Rip Snorter said:
Plenty of places here in Montana that raise grass fed free range beef, chickens as well. It does take a good bit of land and a lot of work.
Same in NC. There's been a resurgence of "drug free" farming the past 10-15 years.
One outfit up the road raises Water Buffalo.
- 2
-
On 4/9/2024 at 8:39 AM, Sedalia Dave said:
That bit about closing the dampers to "hold a fire overnight" is a stretch. Been around my share of old wood cook stoves and the thing they all had in common was you had to feed them constantly because the firebox was so small. You couldn't get one to "hold a fire" for 3-4 hours much less overnight.
Modern wood cook stoves are a completely different animal.
- 1
-
23 hours ago, Crooked River Pete, SASS 43485 said:
What you don't see is that there is usually a center piece between the 2 plates that comes out also. When you start a fire you remove all 3 pieces and that gives you access to the whole fire box. Put in some paper then kindling add match replace plates, some times you had to remove them again to add hard wood.
Exactly. Until you got 'er goin' good you top load.
-
17 minutes ago, Cypress Sun said:
My best friend "runs" a tractor part time when the crops are in season. The tractor is all computerized and GPS controlled. All he does drive it to the fields, get it in position, let it make it's long/slow run, turn it around at the end of the row and try to stay awake. It's fully climate controlled with a cushy seat and AM/FM/CD.
A former co-worker's husband is a Deere field service tech. They're in South Dakota. He said with the GPS plotting they use about 2/3 the fertilizer & seed that they used to because there's no overlap. Goes a long way towards paying for that six-figure piece of equipment. Of course in SD they farm on a whole 'nother scale than NC.
And he sure was "away at school" a lot. Seemed like about as much as he was in the field.
- 3
- 1
Not sure what it's called...
in SASS Wire
Posted
Not a "speed loader", but the Mrs has pushed many-a-round into her 73's using this. Get the round started into the gate with one hand push it in with the pusher. She can load ten faster than I can w/o it.
It's a wood finial drilled to accept the dowel. 45C round for size reference. Might have $1 invested.