Jump to content
SASS Wire Forum

Archived

This topic is now archived and is closed to further replies.

RidgwayPlinker

For Sale: Fred Cornell Press Mounted Wad Punches

Recommended Posts

For sale are six press mounted over powder wad punches manufactured by Fred Cornell.  As measured by my trusty dial caliper, punch diameters are 0.328", 0.403", 0.430", 0.454", 0.460" and 0.516".  In use, the head of a punch locks into a turret press' ram (in replacement of a shell plate).  Four of the punches are mounted in a Lee turret press tool head.  Except for a little surface oxidation on the exterior of the punch bodies, these punches are sharp, smooth, clean and very tightly toleranced.

 

Buffalo Arms sells these punches for $62.95 each.  For the lot of six punches and tool head I'm asking $200 plus $8 for USPS flat rate shipping.  I am only interested in selling them as a lot.  Just think, you get all of this for just a little over what Buffalo Arms is asking for three.  And, Buffalo Arms is out of stock on many of the sizes.

 

Thanks for reading.

 

 

punches.jpg

Share this post


Link to post
Share on other sites

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.