Jump to content
SASS Wire Forum

Gringo Starr

Members
  • Content Count

    5
  • Joined

  • Last visited

Community Reputation

2 Neutral

Previous Fields

  • SASS #
    108789
  • SASS Affiliated Club
    Powder Creek Cowboys

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Thanks Grizz Im going to stick with the modified 10/22 sight for now. It works well with the PGW speed sight on the end. May change it out for a more traditional look later.
  2. Got one on order along with a short-stroke kit and some screws. Looks like the speed sight will be a big improvement. Thanks
  3. Well I tried the triangle file on the 10/22 sight and it worked. Took a while to get that much material off. I was checking it with a caliper every 10-12 strokes to make sure I didn’t go too far. Kind of one of those deals where one stroke of the file could take it over the edge. Painted the raw metal with some matte black paint. Thanks for the input fellas.
  4. Thanks Rafe I got a suggestion from Joe at PGW to file a standard site down with a triangle file to fit the smaller dovetail. I have fold down site from a 10/22 so I’m going to give it a shot. I’ll let you know how it turns out.
  5. I recently bought a Uberti 1866 Carbine in .45LC and when I went to replace the the rear sight I found that the dovetail isn’t a standard 3/8in (.375) slot. It appears to be .340. I’ve looked at Marbles and others and so far haven’t found anything that will fit the .340 dovetail. Any suggestions?
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.