Jump to content
SASS Wire Forum

Search the Community

Showing results for tags '357/38 spl.'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • SASS Wire Questions
    • SASS Wire F.A.Q.
  • SASS Forums
    • SASS Wire
    • SASS Wire Saloon
    • SASS Merchant Corner
    • SASS Wire Classifieds
    • TEAM SASS
  • Event Forums
    • END of TRAIL
    • SASS Events Wire

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests


SASS #


SASS Affiliated Club

Found 2 results

  1. Lee Load-Master progressive 5-hole reloading kit. $225 shipped to your door setup for 1 caliber. $250 setup for any 2 die setups, $270 with all 3 die sets and shell plates. Your choice of dies with appropriate primer setup. Lee 3 die set 44 mag/spl, Lee 4 die set 45 colt, or Lee 4 die set 357/38 spl multitube case feeder with case collator Comes with only 1. 5 hole turret (regardless of how many die sets you choose) Shell plate for dies of your choice (357/38, 44 mag/spl, 45 colt) Lee bullet feeder. You will need to replace the fingers for whatever caliber you want. (this wasnt originally part of this press or calibers offered) NO powder measure included. Sorry I dont have a spare to put with it. I will NOT sell die sets alone until the press is sold I can deliver to Shoot out on the Sandy Creek on Sept 26th or to High Noon Oct 2-4th. If you're picking it up I can take $20 off the price.
  2. I love this little gunn made in 1984. But in the several years I've had it, its had a nasty habit of occasionally feeding one a bit sideways. I've tried different bullet shapes. I've messed a bit with the carrier. Of course, if I run it slowly and deliberately, it feeds fine. But if I speed up, this glitch will show up. I tried swapping out the ejector. This one came with a funky design with a long spring. No improvement. In the night, I got out of Sawmill Mary's 1894 CBL in 357 and started swapping parts. Changed out the carrier and other combinations of parts. Nothing helped. Then I noticed the difference in extractor and place in bolt face. Bolt on left is out of 1894cs. Bolt on right is from a newer JM CBL. Two significant differences. One, on the CBC bolt, the ejector hole is below center line of fireing pin vs at center on the 1894c. Two, the shape of the extractor nose is much different. The CBL extractor has a very heavy angle shape to the front face. The 1894c is just flat. I put the CBL bolt in the 1894cs and ran three 10 round magazine's full through it as fast as I am able without a bobble. While I think I've found the problem, I'm not sure if I can replicate the shape on the 1894c extractor. Or even if I bought an extractor like the CBL it will work in the 1894cs bolt given the different hole location.
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.