ClayDot to RedDot SG loads

[Eyesa Horg]

Just started loading up some SG and a bit into it, I realized that I am running out of the ClayDot I've been using for years! Anyway it's too cold and I'm too lazy to break out the chrono as I switch over to RedDot.

I've been loading 14gr of ClayDot under 7/8oz of shot in 12ga.

Anybody know what a similar load of RedDot would be? 

Thanks for your assistance!

Eyesa

Edited February 14 by Eyesa Horg

[Yul Lose]

I load 13 grains Red Dot under 7/8 oz. shot for 16 gauge.

[Garrison Joe, SASS #60708]

I usually find close performance correspondence between Clay and Red Dots.   Same bulk, too.  good luck, GJ

[Eyesa Horg]

24 minutes ago, Garrison Joe, SASS #60708 said:

I usually find close performance correspondence between Clay and Red Dots.   Same bulk, too.  good luck, GJ

That's what I was expecting by weight. I didn't notice any real difference years ago when I went to the ClayDot from Clays. Just readjusted to drop the same weight. 

[I. M. Crossdraw, SASS# 8321]

I use 10.5grains RD, 7/8 - 1 oz. shot.  Not much difference in shot weight use as far as recoil is concerned.

[Randy Saint Eagle, SASS # 64903]

I didn’t change anything when switching from Clays to Red Dot to Clay Dot. 
 

Randy

[watab kid]

ive always used clays and red dot interchangeably , ive never used clay dot but it seems id just proceed with same load based on above replys , 

[Eyesa Horg]

That's what I was hoping guys, thank you. I shall carry on! 

[watab kid]

good luck , load light to start if you tend to heavier loads , no need to take risks