Jump to content
SASS Wire Forum

Recommended Posts

Posted

In my view, while some increases can be blamed on inflation, the "Shortages" the past several years on many products, gave a signal just how much people were willing to pay for things and how it affected profit margins.

  • Sad 2
Posted
22 minutes ago, Cold Lake Kid, SASS # 51474 said:

In my view, while some increases can be blamed on inflation, the "Shortages" the past several years on many products, gave a signal just how much people were willing to pay for things and how it affected profit margins.

Agreed, when folks pay $300+ for half a pound of Trail Boss, you can sell em anything for whatever you feel like!

  • Like 5
  • Thanks 2
Posted (edited)

I’ve found ammo prices to be somewhat leveled out. I can get 9mm for anywhere from $11.99 to $18.00. Reloading components are still high but I can get .38 bullets no anywhere from $45-$50.00 for 500. Primers are around $70 for 1000. Powder (TiteGroup) is around $45 for a lb.

Edited by Rye Miles #13621
  • Like 1
Posted

I think that's about where things will settle for a while. Primer may drop a bit as we've seen some pretty good sales and doubt distributors are losing money on them.

  • Like 2
Posted (edited)

Why not? Everything else is.

 

The AI demand has driven memory chip prices fully 10x higher than a few years ago.

 

I had to pay $389 (!) for 32gb for my grandsons new computer.  When I owned Micron Technology stock it was $8…. Now $308 the last time I looked.

 

Over production of primers has brought the prices down a bit, so I am hopeful the same will happen to DRAM as production ramps up.  The AI demand will keep prices sky high for quite awhile.

Edited by WD Farren
  • Like 1
Posted

i dont pay a lot of attention anymore - i bought a lot prepandemic because i had sources and i have more of what i use than ill be able to shoot up in my lifetime at the rate im going , with the changes in military calibers and their contract demands - im sure we shall see high prices and shortages in some areas for all the reasons in the article 

  • Like 1
Posted

I bought some high dollar stuff for testing in my 38SW, and OUCH...Buffalo Bore is really proud of their stuff. 

Otherwise, I just make it. 

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.