Jackalope Posted October 13, 2024 Posted October 13, 2024 Anita Margarita was intermittently unable to fully cock one of her Ruger Single Six revolvers during a match yesterday. Something was binding up the hammer somehow. When the grip panels were removed this morning, a small coil spring fell to the table. Upon further disassembly, another small part was found floating around near the trigger/hammer engagement notches and the bolt. As it turned out, the little plunger and spring were originally part of the cylinder pin designed to keep the transfer bar from hanging up on firing pin. Once they worked their way free of the cylinder pin, they migrated inside where the plunger eventually became bound between the hammer and the frame, effectively preventing the hammer from being cocked fully. These Rugers had been short-stroked by Boomstick Jay many years ago and, since he had removed the transfer bars, the spring and plunger were no longer needed, nor were they held captive inside the cylinder pin. Once the foreign objects were removed, the gun works fine again. The cylinder pin on the left shows the spring and plunger that fell out.
Sedalia Dave Posted October 13, 2024 Posted October 13, 2024 Spring and plunger are staked in at the factory, I'm surprised they were able to come out of the cylinder pin.
The Original Lumpy Gritz Posted October 13, 2024 Posted October 13, 2024 First time I have ever seen one come apart like that.
Jackalope Posted October 13, 2024 Author Posted October 13, 2024 It must have been all the severe and violent recoil of the mighty .32 H&R Magnum that finally pounded the staked divot loose. 😁
Randy Saint Eagle, SASS # 64903 Posted October 14, 2024 Posted October 14, 2024 Shotgun Boogie pulled the plungers and springs out of my Bisleys when he short stroked them. At the time I wondered why, now I see it is probably a very good idea. Thanks Randy
Cpt Dan Blodgett, SASS #75655 Posted October 14, 2024 Posted October 14, 2024 Years ago like mid 80s bought a model 66 smith did not shoot it much but in circa 95 when I was at el paso I was shooting it one day at FT Bliss Rod and Gun Club range. Locked up tighter that a drum. Knowing nothing of S&W double actions took it to a friend. Pulled the side plate and found a big machining chip had worked its way under the part that rocks up and down when trigger is pulled. Still know nothing of S&W DAs or would have correctly named the part. Am amazed that the chip stayed in the gun during manufacturing one would think it would have been washed out when they rinsed out any cutting fluids or at worst spotted when the gun was being assembled. Oh well never a problem since and has been shot a lot more than it was in the first 10 years of its life.
watab kid Posted October 14, 2024 Posted October 14, 2024 interesting , ive never seen that assembly come out like that either ,
Mister Badly Posted October 14, 2024 Posted October 14, 2024 22 hours ago, Jackalope said: It must have been all the severe and violent recoil of the mighty .32 H&R Magnum that finally pounded the staked divot loose. 😁 Just like a dang jackhammer I imagine. 😉
Recommended Posts
Archived
This topic is now archived and is closed to further replies.