Jump to content
SASS Wire Forum

FS Ruger grip frames and Sambar stag grips SOLD PENDING FUNDS, THANKS.


Recommended Posts

These will fit either New Vaquero's or original Vaquero's.  Aluminum grip frames with Sambar stag grips.  Lightly round butted and the grips have been nicely fitted to the frames.  Great way to lighten the guns for smaller stature shooters and add a nice look.  First I'll take it posted here gets it.  Thanks.

20240721_064511.jpg

20240721_064517.jpg

20240721_064431.jpg

20240721_064443.jpg

20240721_064458.jpg

Link to comment
Share on other sites

absolutely gorgeous.  Are the frames actually smaller or just lighter?  I have a set of OMV and NMV, both Bisleys.  Can I assume that they would bolt on okay?

Link to comment
Share on other sites

5 hours ago, Dred Bob said:

absolutely gorgeous.  Are the frames actually smaller or just lighter?  I have a set of OMV and NMV, both Bisleys.  Can I assume that they would bolt on okay?

@Dred Bob They are standard XR3-RED frames, so "regular" plow handle size.  They are light because of the aluminum and the slight round butt typically feels and points nicer.  They will screw on to either NMV or OMV just fine and as with any grip frame swap the sides may or may not be a "perfect" fit.

Link to comment
Share on other sites

10 hours ago, boom pop said:

Just when i stopped shooting bisleys

@boom pop They are standard XR3-RED frames, so "regular" plow handle size.  NOT Bisley.

Link to comment
Share on other sites

  • Fireball #7709 Life changed the title to FS Ruger grip frames and Sambar stag grips SOLD PENDING FUNDS, THANKS.

Thank ypu fireball. Those frames with the grip panels attached weigh a mere 5 ounces apiece , i have to be careful not to throw those pistols down range forgetting they are in my hand

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.