Jump to content
SASS Wire Forum

Carrier Pivot Pin for an IAC 1897


Recommended Posts

Thanks for the replies.
I sent an e-mail to Outlaw Gambler, & left a phone message for Pisco gunsmithing.
I know there are pins on ebay.
So, maybe we can get this done.

--Dawg

Link to comment
Share on other sites

12 minutes ago, Prairie Dawg, SASS #50329 said:

Thanks for the replies.
I sent an e-mail to Outlaw Gambler, & left a phone message for Pisco gunsmithing.
I know there are pins on ebay.
So, maybe we can get this done.

--Dawg

Buy 2 ;)

Link to comment
Share on other sites

I made one from a long drill bit, 3/16" diameter, with hardly any effort.  Turned a retaining groove for the set screw in a mini-lathe, could have done it with a triangular file and my drill press with a couple minutes more work.   Nothing taken off the drill bit shank diameter.  Has run in my IAC replica 97 now for four matches.....

 

good luck, GJ

 

 

Link to comment
Share on other sites

Outlaw Gambler says he has them, so I'll buy it from him!

Thanks for everybody's help.

--Dawg

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.