Hangry Bob Posted April 18, 2023 Share Posted April 18, 2023 Does anyone know the thread size for an ejector spring screw for an 1897? I have an 1899 production model and I am going to be adding the ejector spring and need to know the tap size. Link to comment Share on other sites More sharing options...
Fretless Posted April 20, 2023 Share Posted April 20, 2023 I don't have an answer to your question, but I am curious.... Did the early years of the model 1897 not have an ejector spring? What pushed the empty hull off of the extractors? Link to comment Share on other sites More sharing options...
The Original Lumpy Gritz Posted April 20, 2023 Share Posted April 20, 2023 Here's the screw used. Give these folks a call for thread information. https://jackfirstinc.com/winchester-97-ejector-spring-screw-29-11997 Link to comment Share on other sites More sharing options...
Hangry Bob Posted April 20, 2023 Author Share Posted April 20, 2023 51 minutes ago, Fretless said: I don't have an answer to your question, but I am curious.... Did the early years of the model 1897 not have an ejector spring? What pushed the empty hull off of the extractors? Correct, the first iteration of the 1897 did not have an ejector spring. This was one of the changes incorporated into the C series. There pre-C series used only the ejector block. Link to comment Share on other sites More sharing options...
Larsen E. Pettifogger, SASS #32933 Posted April 20, 2023 Share Posted April 20, 2023 3-56 Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.