Jump to content
SASS Wire Forum

Lookin for floor plate for 788 Remington 30-30 0r 222,223


Recommended Posts

Here we go again, tryin to find the impossible! GPC doesnt have it. So, SASS buddies help me out! And, the front guard screw? Ur, well the smaller of the 2, I need as well.

Thanks, Parson

Always a project!!!

I got a trigger guard comin, but the 308 family floorplate will not work for the 30-30.BUT the bolt pattern on the 222,223 will line up, so, with a mill l can make it work.

Thanks for lookin

Parson

Link to comment
Share on other sites

no, there is a floor plate or trigger guard plate. The trigger guard hooks into a foreward slot screw behind the trigger the mag goes into a cut out in the bottom. I have a 223, and have had a 308. Im chasing parts to rebuild a 30-30. The 308 is longer than the 222-223-30-30. But can machine out the mag slot on a 222.

Parson

Link to comment
Share on other sites

if you are looking to do a 3030, they are the same action length as the 222, 223 and 30-30 at 6 5/16ths.   The bottom metal/floor plates are not the same on them?  The 243/308 action is only a few 16ths longer at 6 9/16ths....quarter of an inch difference so one or the other should work.  I dont think the 3030 has different bottom metal does it?

Measured from the rear edge of the bridge to the front edge of the ring, the .44 Mag is 5-5/8", the .222, .22-250, and .30-30 are 6-5/16," and the 243 and 308 are 6-9/16.  These measurements were taken on rifles in my collection

 

Here are some good links to find measurements and info etc and after market parts that were made:

http://ps-2.kev009.com/ohland/Rem788/Remington_788.html

https://cfnparts.com/index.php?route=product/category&path=169

http://ataleoftwothirties.com/?page_id=422

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.