Jump to content
SASS Wire Forum

WTB 32-20 brass


Recommended Posts

Howdy Kid,

Here's a little info to keep in mind.  R-P brass is longer than Winchester or Starline.  If you have mixed brass you might have issues with crimping for rifle rounds.  You could trim the brass so all is the same length.  Or just use a specific headstamp.  Personally, I use R-P only for smokeless, and I use any headstamp for BP.  I set the crimp die to crimp in the groove with R-P brass, so the mouth of the brass is a little below the crimp groove with the other brands but that's okay because the bullet is sitting on powder and will not collapse into the case in a rifle magazine.  Regardless of what you end up with, load a dummy first and use your gun's chamber as a go/no-go gauge to see if the shoulder is set low enough.  Good luck.

Fun caliber.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.