Jump to content
SASS Wire Forum

Help with cocking levers


Hawg Runner, SASS #61139

Recommended Posts

Posted

Tried both in, no go. Put stock right side in, only right side works,  same with the left side when put stock one in and Poppa Dave on right the right does not work only the left. In other words neither side works when placing Poppa Dave cocking levers in.

Posted

"BAIKAL & REMINGTON SPR 210/220 DOUBLE BARREL SHOTGUNS



Shooter

   I have redesigned the Baikal Cocking levers. The cost is $24.95 per set.
Levers are made from Cold Rolled Steel, Case Hardened and Nickel Plated.

   Send me your address & phone number and I will send you a set of levers.
Install levers in your shotgun and try them. Baikal or the Remington SPR210 & SPR220 Double Barrel Shotguns are not made to close tolerances. Levers will not work in some guns.

   If the levers work send me a check in the self addressed stamped envelope or place the levers in the envelope and return them to me.

   NO COST BUT YOUR TIME TO INSTALL THEM


Thanks for your interest

Papa Dave
SASS #17266"

You may have to do some comparison to the old ones-looking for wear points on new ones when installed and perhaps some extra contouring...
it will probably be a "file a bit and try" numerous times process.....not quite a drop in part according to what he used to say...if I remember correctly, mine took a bit of fiddling and a couple tries

edited to add: at the same time I did the 1911 cut down springs for the cocking springs..dont know if that made a difference.


 

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.