Jump to content
SASS Wire Forum

Collet bullet puller - RCBS, Hornady or other?


Chief Rick

Recommended Posts

I just replaced my old one with the Frankford Arsenal one that uses Lee shell holders. I like it a lot.

Link to comment
Share on other sites

Hornady Cam Lock Bullet puller https://www.hornady.com/reloading/presses/lock-n-load-accessories/bullet-pullers-bullet-collets/#!/

 

I have used one of these for over 10 years, works great, get the correct size collet for the bullet diameter you are going to pull.

https://www.hornady.com/reloading/presses/lock-n-load-accessories/bullet-pullers-bullet-collets/#!/

 

TB

Link to comment
Share on other sites

11 hours ago, Hells Comin said:

The cam lock is designed for jacketed rifle bullets. Little surface area to grab onto and  Crunches lead pistol bullets in my experience. 

HC, yes that what they say, I can tell you from personal experience I have pulled cast & coated bullets for years. At one point I pulled 300+ bullets to check an issue I had with powder levels. They cam lock unit works great!

TB

Link to comment
Share on other sites

25 minutes ago, Turquoise Bill, SASS #39118 said:

HC, yes that what they say, I can tell you from personal experience I have pulled cast & coated bullets for years. At one point I pulled 300+ bullets to check an issue I had with powder levels. They cam lock unit works great!

TB

I have the RCBS and have had the same experience as Turquoise Bill. 

Tully

Link to comment
Share on other sites

46 minutes ago, Turquoise Bill, SASS #39118 said:

HC, yes that what they say, I can tell you from personal experience I have pulled cast & coated bullets for years. At one point I pulled 300+ bullets to check an issue I had with powder levels. They cam lock unit works great!

TB

Can you show me how to use it ? If so,

I'll be there in 15 minutes.

 

Link to comment
Share on other sites

Frankford Arsenal 

Frankford Arsenal Pile Driver Bullet Puller https://www.amazon.com/dp/B084HLTTJ7/ref=cm_sw_r_cp_api_glt_i_36JN6TKD0WTZNHH8B4GH?_encoding=UTF8&psc=1

 

This one and have pulled a bunch without any effort. It is a tad expensive but no need to hammer around :)

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.