Jump to content
SASS Wire Forum

WTB, Dillon 650/750 case feeder and other accessories


Recommended Posts

I just setup my 2nd Dillon 650 a couple weeks ago and now I am looking for any used accessories that you may have laying around that you don't need.

 

I am looking for a Dillon case feeder with or with out shell plates as I have a full set of shell plates from my 1st machine.

It can be the feeder with the 2 speed switch like I currently own or the current version that uses  potentiometer for speed control.

 

I could use a set of Dillon 38spl/35 carbide dies ( 3 die set)(stock number 14400) ( I have 357 dies, just would like a Dillon set)

 

I could use  (2) Power Check Systems (Dillon Stock number 21044)

 

I looked on ebay, and I can get a roller handle and bullet trays as after market parts, but really prefer Dillon parts.

 

Let me know what you have and post or PM me.  Kinda a long shot here but looking to save a bit of cash if possible. Thanks

 

Maddog McCoy

 

 

Link to comment
Share on other sites

I have made some good buys off of MeWe which is a social media platform like facebook but run by conservatives so you can buy and sell guns, ammo and loading equipment.  Free app, sign up and look for pages.  SASS has a couple of pages, look up the "dillon 650/750 loaders" page and the "everything reloading" which is the equipment page and "everything reloading components" which is the page for components.  

  • Like 1
Link to comment
Share on other sites

15 hours ago, Jack Spade said:

I have made some good buys off of MeWe which is a social media platform like facebook but run by conservatives so you can buy and sell guns, ammo and loading equipment.  Free app, sign up and look for pages.  SASS has a couple of pages, look up the "dillon 650/750 loaders" page and the "everything reloading" which is the equipment page and "everything reloading components" which is the page for components.  

You just talked me into trying MEWE.:lol:

  • Like 2
Link to comment
Share on other sites

There is also a guy on there with a page, Roberts Bullet and Case feeders, that 3d prints case feeders.  Probably not what the OP wants because he already has plates but I ordered one for one of my 650's that didn't have a case feeder.  It works really well and was a little cheaper than the dillon with some improvements over the dillon. 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.