Jump to content
SASS Wire Forum

38 spl. Load data w/ WST ???


Silver Sam, SASS #34718L

Recommended Posts

I don't shoot WB too much anymore, but I do have several lbs. of WST powder that I need to use up at some point.

And I'm not finding much Load info for it on 38 spl................

 

Anyone using WST in their 38's with 105 or 125 gr. bullets ???

Link to comment
Share on other sites

I'd start with 3.8 grains WST and work down until you get unburned powder.  WST loads about like 231, but can only handle the lower half of the velocity range that 231 does.   In straight wall pistol cartridges.

 

Then again, folks who ARE shooting WB might just have some Clays or Red Dot or TiteGroup they can spare in a trade for WST!

 

good luck, GJ

 

 

 

 

Link to comment
Share on other sites

11 hours ago, Silver Sam, SASS #34718L said:

I don't shoot WB too much anymore, but I do have several lbs. of WST powder that I need to use up at some point.

And I'm not finding much Load info for it on 38 spl................

 

Anyone using WST in their 38's with 105 or 125 gr. bullets ???

I have use  WST off and on in a 125gr bullet 3.3 to 3.4 works great 

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.