Jump to content
SASS Wire Forum

Found Marlin Bullseye


Recommended Posts

Recently acquired an Marlin 1894 Cowboy that is missing the butt plate and the the bullseye inlay on the stock. Anyone have one or both?

JFN

Link to comment
Share on other sites

I think I got that Butt Plate packed away some place

4 hours ago, J. Frank Norfleet said:

Recently acquired an Marlin 1894 Cowboy that is missing the butt plate and the the bullseye inlay on the stock. Anyone have one or both?

JFN

 E-Mail jgp3749@cox.net. Will try to find it

Link to comment
Share on other sites

Frank Norfleet sending you a PM & here is photo..

 

Is this it?  Sold my Marlin Cowboy several years ago and had a Brass Butt plate made & put on the Marlin Cowboy rifle.

Marlin Butt Plate 2.JPG

Marlin Butt plate 3.JPG

1374271527_MarlinButtplate.JPG

Link to comment
Share on other sites

41 minutes ago, J. Frank Norfleet said:

That looks like it. Screws?

$$$$???

Yeh screws around here also will have to dig. Been under the weather for almost a month so hang in there.

 

Jackrabbit Joe

1447347259_MarlinButtplatewithscrews5.JPG

421752743_MarlinButtplatewithscrews4.JPG

Link to comment
Share on other sites

Ok Frank sending you a PM pilgrim.

 

JRJ

Link to comment
Share on other sites

Listed as out of stock,But you might be able to back order it here.

https://www.gunpartscorp.com/products/432130B

Link to comment
Share on other sites

1 hour ago, Long Fingers, SASS#56813 said:

Kinda thought a mosaic pin might look nice for a replacement? They come in different diameters if you could find the right size. 

E60B51B6-CA17-4ECC-B21E-8F332505356D.jpeg

A thought

thanks

Link to comment
Share on other sites

16 minutes ago, Major E A Sterner #12916 said:

Listed as out of stock,But you might be able to back order it here.

https://www.gunpartscorp.com/products/432130B

Everybody is out of stock. My guess is that since Marlin was sold to Remington, then Remlin eventually discontinued installing the bullseye and Remlin was sold to Ruger there are few factory parts available.

 

I was hoping that someone might have one or a half of one floating out there.
JFN

Link to comment
Share on other sites

1 hour ago, Rough 'N Ready Rob said:

J. Frank,

   I have about a one third piece, I think with a little piece of dowel in the hole first it should work.

Give me a address and I will get it in the mail.

  Rob 

Woo Haa! That's all I need. A piece of dowel, epoxy, and maybe some wood filler, that'll work. I do not understand why someone would think the bullseye is where you screw in a sling swivel. 

Thank you, PM with address sent

JFN

Link to comment
Share on other sites

10 hours ago, Tater Head said:

Sounds like you've found what you need. If it doesn't work out you might try this guy. Don't know if hestill has them or not?

https://www.marlinowners.com/threads/marlin-bullseyes-for-sale.85946/

 

Good Luck,

Tater

Thank you

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.