Jump to content
SASS Wire Forum

ROA's and CCI#11 caps


Sgt. Hochbauer, SASS #64409

Recommended Posts

I have never had positive results with CCI No. 11s period. 

 

I know in these times they might be the only thing you can find, so if the stock nipples are larger diameter than the slix, you might have slightly better results.

 

Back before I shot SASS and knew very little about cap guns I found that No. 11s worked okay on older slightly worn out nipples that had been mushroomed slightly from dry firing.

Link to comment
Share on other sites

Hey Sgt.

I use the stock nipples in my ROA and CCI #11's with good results; always goes bang, they don't seem to fall off to block the rotation, etc. Remington 11's also. I've tried CCI #10's, seem a little too tight. YMMV

Maybe 10's would work better with the slix nipples?

Link to comment
Share on other sites

2 hours ago, Col. Cornelius Gilliam, SASS#5875TG said:

I've had great results with the stock ROA nipples and CCI No. 11 caps.  Never seen the need to change.

 

No problems if they are seated good during loading.

Same here. No problems with my ROA and CCI 11

Link to comment
Share on other sites

I went to the range and the CCI # 11's and my ROA's did not get along with the slix shot nipples. Switched to the stock nipples not really much better. Will ration what I have on hand  so I have enough for EOT . Will just have to shoot the cartridge guns...such a dilemma.

 

Hochbauer

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.