Jump to content
SASS Wire Forum

Please delets


Recommended Posts

Don’t know about bushings or production dates. 
They are not consecutive serial numbers.

They were purchased on GB seperatley.

One was listed at time as unturned new.

The other listed as fired very little.

After sending off to Jim Martin for action job

I shot them twice, around 200 rounds.

Link to comment
Share on other sites

For those that don't know Jim Martin is considered on of the best Colt smiths out there.  There is an acknowledgment to him in the Kuhnhausen shop manual.  His work alone adds a lot to the value of the guns to a shooter. 

Link to comment
Share on other sites

If the serial number is greater than 30K, ie S31xxxA it will have a remove able cylinder bushing. 
  If you shot them and cleaned them what they are asking is if the cylinder  had a remove able bushing inside the cylinder that

the  cylinder pin goes thru. Early 3rd gens had a fixed bushing like a Ruger.

Hope this helps?

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.