Jump to content
SASS Wire Forum

Repairing hinge on handle of Rugged Gear cart


Hoss

Recommended Posts

Anybody figured out a way to repair the plastic hinge on a rugged gear cart handle?   I’ve tried JB Weld, no luck. 

Link to comment
Share on other sites

18 minutes ago, The Original Lumpy Gritz said:

Call RG for replacement. 

OLG 

This is what I did.

They took care of me really quickly. 

Nice folks
Regards

:FlagAm:  :FlagAm:  :FlagAm:

Gateway Kid

Link to comment
Share on other sites

When Brisco Joe was their man I had really good luck with repairs because Joe would go the extra mile for ya.  After they discontinued Joe's services things have not been quite as good for me.

Link to comment
Share on other sites

I know I can buy a replacement hinge joint. I’m going to experiment with some sort of plastic bonding glue or epoxy resin. I was just curious off anybody had found something that worked. The hinge is a definite weak point. I’ve learned not to lean on the handle, but others will lean on it. 

Link to comment
Share on other sites

do post what you try - i suspect if this is the weak point , others will be looking in soon , might ask the mfgr if they have started working on this fix , if you have the issue others must as well 

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.