Jump to content
SASS Wire Forum

reduced FS: Millington 1863 Remington Pocket conversion - .32 S&W Long


LQ Jones

Recommended Posts

Here's an interesting one. Bob Millington thin plate conversion on a Pietta steel frame repop, defarbed. .32 S&W short or long. Super tight; I've only shot it a few times and I got it years ago. No BP cylinder; useless anyway

 

Not sure if Bob is even still doing conversions.

 

reduced - Asking $775 shipped to FFL. 

IMG_20210111_110007620.jpg

IMG_20210111_110023292.jpg

IMG_20210111_110043004.jpg

IMG_20210111_110111844.jpg

IMG_20210111_110131497.jpg

IMG_20210111_110148144.jpg

IMG_20210111_110215762.jpg

IMG_20210111_110245765.jpg

IMG_20210111_110301812.jpg

Link to comment
Share on other sites

On 1/12/2021 at 10:30 AM, Fireball #7709 Life said:

Will 327 Federal fit?  Asking for a friend:blink:

 

Lord I hope not! I believe the pressures would be too much. Even the conversion cylinders for the Ruger Old Army state that they are rated for nothing hotter than cowboy loads

Link to comment
Share on other sites

6 hours ago, Muley Gil SASS # 57795 said:

 

Lord I hope not! I believe the pressures would be too much. Even the conversion cylinders for the Ruger Old Army state that they are rated for nothing hotter than cowboy loads

 

The cylinder isn't long enough, it was a joke.:excl:

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.