Cottonmouth Mark 59 Posted January 1 Share Posted January 1 Stupid question. I have Uberti SAA clones. The cross pin(?) that holds the cylinder pin/axle keeps coming loose. Is this OK to Loctite Blue? Link to post Share on other sites
Nickel City Dude 341 Posted January 1 Share Posted January 1 I did it on mine. Link to post Share on other sites
Ol Number4 133 Posted January 1 Share Posted January 1 Try some clear fingernail polish on all your screws. Easy to dab on, invisible, and easy to release with Acetone. Ol' #4 Link to post Share on other sites
Cottonmouth Mark 59 Posted January 1 Author Share Posted January 1 Locktite blue it is tomorrow. I think the random binding I’m feeling after 50-100 rounds is that loosening up and letting the cylinder pin walk a little Link to post Share on other sites
High Spade Mikey Wilson 330 Posted January 1 Share Posted January 1 I used the Loctite Blue on all of the cylinder lock pins on my Uberti's . Link to post Share on other sites
Sgt. Hochbauer, SASS #64409 129 Posted January 1 Share Posted January 1 I use Loctite blue for the lever screw on my 66a dab will do ya. Hochbauer Link to post Share on other sites
Nickel City Dude 341 Posted January 1 Share Posted January 1 14 hours ago, Cottonmouth Mark said: Locktite blue it is tomorrow. I think the random binding I’m feeling after 50-100 rounds is that loosening up and letting the cylinder pin walk a little You are correct. If the base pin is not fully in where it belongs the cylinder will bind. Don't ask me how I know. Link to post Share on other sites
The Original Lumpy Gritz 7,565 Posted January 1 Share Posted January 1 Yes, to a very small 'dab' of blue. Shake the container vigorously for 5-10 seconds. OLG Link to post Share on other sites
Recommended Posts
Archived
This topic is now archived and is closed to further replies.